7
Using the Utility Mode
7-8 Di152/Di183
Erase Setting (Left, Upper, and Frame)
Set the erase width for each of the Left, Upper, and Frame Erase copies in the
range between 5 mm and 20 mm (in 1-mm increments).
l The default value is “10 mm” for Left, Upper, and Frame Erase.
Auto Panel Reset
Select the time it takes the auto panel reset function to be activated from among
“30 seconds,” “1 min,” “2 min,” “3 min,” “4 min,” or “5 min,” or not activated at
all.
l The default value is “1 min.”
Energy Saver
Set the time it takes the copier to enter the Energy Saver mode, from 1 min to 240
min (in 1-min increments).
l The default value is “15 min.”
Auto Shut OFF
Set the time it takes the Auto Shut OFF function to be activated, from 15 min to
240 min (in 1-min increments). To disable the Auto Shut OFF function, first
“authorize” the “Disable Auto Shut OFF” under the Administrator Mode (p.7-26)
before selecting “Auto Shut OFF disabled.”
l The default value is “30 min.”
Density (ADF)
Adjust the copy image density level when the copier is equipped with an
Automatic Document Feeder.
Mode 1: Used for the standard original, such as a word-processor made
document.
Mode 2: Effective in reproducing a pale original, such as a faint pencil-written
document.
l The default value is “Mode 1.”
Printer Density
Select the image density level of copies and printed pages from among “-2,” “-1,”
“0,” “1,” or “2.”
The smaller the value, the lighter the image, and the greater the value, the darker
the image with “0” as the central value.
l The default value is “0.”
Chapter07.fm Page 8 Wednesday, August 8, 2001 1:47 PM
To Next Page
Loading...
Need help?
General
