3
Before Making Copies
3-18 Di152/Di183
Energy Saver
Instead of turning OFF the copier, it can be set into a standby state
(Energy Saver mode).
To set the copier into the Energy Saver mode, press the [Energy Saver]
key. In addition, if the copier is not used for a set length of time, it will
automatically enter the Energy Saver mode. The default length of time is
15 min.
To cancel the Energy Saver mode, press any key on the control panel.
✎
Note
If the Auto Shut OFF function is activated while the copier is in the
Energy Saver mode, the copier will automatically turn itself OFF.
✎
Tip
The length of time before the copier enters the Energy Saver mode
can be set between 1 min and 240 min.
For more details, refer to “User’s Choice” (p.7-2, p.7-8).
Auto Shut OFF
If a set length of time elapses after the copier has been operated last, the
copier is designed to automatically turn itself OFF to save energy. The
default length of time is 30 min.
✎
Tip
The length of time before the Auto Shut OFF function is activated can
be set between 15 min and 240 min. The Auto Shut OFF function can
even be disabled. For more details, refer to “User’s Choice” (p.7-2,
p.7-8 and p.7-26).
Auto Copy Start
If a document is loaded and the [Start] key is pressed during the period
after the copier has been turned ON but before it is ready to make copies,
the copier will automatically start the copy cycle as soon as it completes
the warm-up cycle.
Di152_183.book Page 18 Wednesday, August 8, 2001 10:57 AM
To Next Page
Loading...
Need help?
General
