108 DATA-TRANSFER MODE
DISCONNECTING THE CAMERA FROM A COMPUTER
Windows
®
XP, 2000 Professional, and Me
To disconnect the camera, click once on the unplug-or-eject-hardware icon
located on the task bar. A small window will open indicating the device to be
stopped.
When more than one external device are connected to the computer, repeat the
procedure above except right click on the unplug-or-eject-hardware icon. This will open
the unplug-or-eject-hardware window after clicking on the small window indicating the
unplug-or-eject-hardware routine.
Click on the small window to stop
the device. The safe-to-remove-
hardware window will open. Click
on “OK” to close the window, turn
the camera off, and then
disconnect the USB cable.
Never disconnect the camera when the access lamp is red - the data
or memory card may permanently be damaged.
To Next Page
Loading...
Need help?
General
