Four camera sensitivity settings can be selected with a still image: Auto, 50, 100, 200,
400; the numerical values are based on an ISO equivalent. ISO is the standard used to
indicate film sensitivity: the higher the number, the more sensitive the film. Sensitivity can
be changed in section 2 of the recording-mode menu (p. 43).
The auto setting automatically adjusts the camera
sensitivity to the light conditions between ISO 50 and ISO
160. When any other setting than auto is used, “ISO” and
the set value will appear on the LCD monitor.
A specific sensitivity setting can be selected. As the ISO
value doubles, the camera sensitivity doubles. Like grain in
silver-halide film that increases with speed, noise increases
with the sensitivity in digital imaging; an ISO setting of 50
will have the least noise and 400 will have the most.
52 RECORDING - ADVANCED OPERATION
CAMERA SENSITIVITY - ISO
FLASH RANGE AND CAMERA SENSITIVITY
Because of the optical system, the flash range is not the same at the lens’ wide-angle
position as it is at the telephoto position.
AUTO
50
100
200
ISO setting
400
0.15m ~ 2.5m ( 0.5ft. ~8.2ft)
0.15m ~ 1.4m ( 0.5ft. ~4.6ft)
0.15m ~ 2.0m ( 0.5ft. ~6.6ft)
0.15m ~ 2.8m ( 0.5ft. ~9.2ft)
Flash range (wide angle)
0.15m ~ 3.2m (0.5ft. ~ 10.5ft)
0.15m ~ 1.8m ( 0.5ft. ~ 5.9ft)
0.15m ~ 2.5m ( 0.5ft. ~8.2 ft)
0.15m ~ 3.6m ( 0.5ft. ~11.8 ft)
0.15m ~ 4.0m ( 0.5ft. ~13.1ft)0.15m ~ 5.1m ( 0.5ft. ~16.7 ft)
Flash range (telephoto)
To Next Page
Loading...
Need help?
General
