20 GETTING UP AND RUNNING
INSTALLING AND REMOVING A MEMORY CARD
An SD (Secure Digital) Memory card or MultiMediaCard must be inserted for the camera
to operate. If a card has not been inserted, a no-card warning will appear on the LCD
monitor; the shutter can still be released and a single image can be captured (p. 62).
Always turn off the camera and confirm the indicator lamp is not orange and
blinking before changing the memory card, otherwise the card may be
damaged, and data lost.
Slide the battery-chamber door toward the
bottom of the camera to release the safety catch
(1). Open the door.
Insert the memory card all the way into the card
slot and then release (2). The card should catch
in the slot.
Insert the card so the face is toward the front of
the camera. Always push the card in straight,
never at an angle. Never force the card. If the
card does not fit, check that it is orientated
correctly. If a MultiMediaCard is inserted
incorrectly, it will lock, but the card chamber door
will not close.
To eject a memory card, press the card into the
slot and release (3). The card can now be pulled
out.
Close the battery-chamber door and slide it
toward the top of the camera to engage the
safety catch (4).
1
2
3
4
To Next Page
Loading...
Need help?
General
