KTM 1290 Super Adventure User Manual

16 ELECTRICAL SYSTEM 198
16.12 Changing the turn signal bulb
Note
Damage to reflector Reduced brightness.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
M00854-10
– Remove the screw on the front of the turn signal housing.
–
Carefully remove diffuser

.
–
Press bulb

carefully into the socket, turn it counterclockwise by about 30°, and pull
it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
– Press the new bulb carefully into the socket and turn it clockwise until it stops.
Turn signal (RY10W / socket BAU15s) ( p. 237)
– Check the turn signal to make sure it is functioning properly.
– Position the diffuser.
Info
Hook in projection

at recess

.
– Insert the screw and first turn it counterclockwise until it engages in the thread. Tighten
the screw slightly.

KTM 1290 Super Adventure Specifications

General

Displacement	1301 cc
Transmission	6-speed
Power	160 hp (118 kW)
Torque	138 Nm
Fuel Capacity	23 liters
Front Suspension	WP Semi-active Suspension
Rear Suspension	WP Semi-active Suspension
Front Brakes	Dual 320 mm discs, 4-piston calipers
Rear Brakes	267 mm disc, 2-piston caliper
ABS	Yes
Traction Control	Yes, MTC (Motorcycle Traction Control)
Wheelbase	1, 560 mm