MAINTENANCE WORK ON CHASSIS AND ENGINE 84
Info
The fluid level rises with increasing wear of the clutch lining disc.
Avoid contact between brake fluid and painted parts. Brake fluid is corrosive!
Use only clean brake fluid from a sealed container!
400339-10
– Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
– Remove screws .
– Remove cover with membrane .
600683-10
– Fill bleeding syringe with the appropriate hydraulic fluid.
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 ( p. 116)
– On the slave cylinder, remove bleeder screw and mount bleeding syringe .
400340-10
– Inject the liquid into the system until it escapes from bore hole of the master
cylinder without bubbles.
– To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
– Remove the bleeding syringe. Mount and tighten screws bleeder screw.
– Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level under top level of container 4 mm (0.16 in)
– Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt fluid immediately with water.
13.100Checking the basic position of the shift lever
400692-10
– Sit on the vehicle (facing the direction of travel) and measure the gap between the
top of the boot and shift lever .
Gap between the shift lever and the top
of the boot
10… 20 mm (0.39… 0.79 in)
» If the distance does not meet the specifications:
–
Adjust the basic position of the shift lever. x ( p. 84)
13.101Adjusting the basic position of the shift lever x
100805-10
– Remove screw and remove shift lever .
To Next Page
Loading...
Need help?
General
