SERVICE WORK ON THE CHASSIS 12
85
12.32 Changing the glass fiber yarn filling of the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
– Allow the exhaust system to cool down before performing any work on the vehicle.
Info
Over time, the fibers of the glass fiber yarn escape and the damper “burns” out.
Not only is the noise level higher, but the performance characteristics change.
Preparatory work
– Remove main silencer. ( p. 83)
V01734-10
Main work
(All EU models)
–
Remove screws
1
.
–
Take off silencer cap
2
with O-ring
3
.
– Remove the old glass fiber yarn filling.
–
Clean the parts that need to be reinstalled and check for
damage.
–
Mount the new glass fiber yarn filling
4
in the main
silencer.
– Mount the O-ring on the silencer cap.
– Position the silencer cap.
– Mount and tighten all of the screws.
Guideline
Screws on main
silencer
M5 7 Nm (5.2 lbf ft)
V01735-10
(XCF‑W)
–
Remove screws
1
.
–
Take off silencer cap
2
with O-ring
3
.
– Remove the old glass fiber yarn filling.
– Clean the parts that need to be reinstalled and check for
damage.
–
Mount the new glass fiber yarn filling
4
in the main
silencer.
– Mount the O-ring on the silencer cap.
– Position the silencer cap.
– Mount and tighten all of the screws.
Guideline
Screws on main
silencer
M5 7 Nm (5.2 lbf ft)
To Next Page
Loading...
Need help?
General
