ELECTRICAL SYSTEM 124
101146-11
– Position holes onto holding lugs .
101145-10
– Position the headlight mask. Mount and tighten screws .
Guideline
Remaining chassis screws M6 10 Nm (7.4 lbf ft)
– Check that the lighting is functioning properly.
13.7Changing the parking light bulb
Note
Damage to reflector Reduced luminance.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
– Switch off all power consumers and the engine.
To Next Page
Loading...
Need help?
General
