SERVICE WORK ON THE CHASSIS 82
10.7Mounting the seat
101139-10
– Position front recesses of the seat on the oval head screws of the fuel tank, lower
the rear and simultaneously push it forward. Both lugs must hook into the frame and
locking bolt must be inserted into the lock housing.
The seat engages with an audible click.
– Finally, check that the seat is correctly mounted.
10.8Mounting the helmet lock on the vehicle
Warning
Danger of accidents Impairment of ride behavior and vehicle operation if a helmet or helmet lock is attached to the vehicle.
– Do not use the helmet lock for holding a helmet or other objects during the journey. Always remove the helmet lock before start-
ing out.
101140-10
– Remove the seat. ( p. 81)
– Position the steel cable from the tool set with one loop on the lug .
Steel cable (60012015000)
– Guide the steel cable through the helmet opening.
– Then position the free loop of the steel cable on the lug.
– Position the helmet carefully on the side of the vehicle.
– Mount the seat. ( p. 82)
To Next Page
Loading...
Need help?
General
