II-133
WSM Minor Change II Service Engineering Section
3-13 Servive hour meter check
The service hour meter can be checked and altered by selecting Other menu, Other menu, and Service hour
meter.
Only the display selector switch is used to make value changes. The service hour meter will be changed
when the meter is replaced, because the service hour meter will not be synchronized with the hour meter,
and warnings will not be displayed in a timely manner.
As you reach to this menu, first box is blinking to ready to change the digit. Push the
SW in short, the number will be incremented. Push the SW longer, the number will
be fixed and shifted to next box. After fixing all boxes, the beep sounds three times
and automatically returns to service hour meter with new service hours.
3-14 Servive hour meter delete
A deletion method of the service hour meter can be set by selecting Other menu, Other menu, and Service
warning selection.
Auto: North America & Oceania - version
The service hour meter will be turned off when the key is turned OFF and ON 10 times in total.
Manual: EU - version
The service hour meter will be turned off with the working lamp switch pressed continuously for 3 seconds.
Note:
Change in Service Hour Meter
North American specifications: By default set to auto.
European specifications: By default set to manual.
Turn off the service hour meter with the working lamp switch pressed.
3-15 Set-up time
The hour meter used for model settings can be checked by selecting Other menu, Other menu, and Set up
hour meter.
3-16 Software version
The software version can be checked by selecting Other menu, Other menu, and Soft version.
To Next Page
Loading...
Need help?
General
