PERIODIC SERVICE88
BOiling
To avoid personal injury:
A Be sure to stop the engine and remove the key
before oiling.
BChecking Engine Start System
To avoid personal injury:
A Do not allow anyone near the tractor while
testing.
A If the tractor does not pass the test, do not
operate the tractor.
C Preparation before testing.
1. Place all control levers in the "NEUTRAL" position.
2. Set the parking brake and stop the engine.
[GST / Manual Transmission Type]
C Test: Switch for the shuttle shift lever.
1. Sit on the operator's seat
2. Shift the shuttle shift lever to the forward or reverse
position.
3. Depress the clutch pedal fully.
4. Disengage the PTO clutch control switch or lever.
5. Turn the key to "START" position.
6. The engine must not crank.
7. If it cranks, consult your local KUBOTA Dealer for this
service.
C Test: Switch for the PTO clutch control switch or
lever.
1. Sit on the operator's seat.
2. Engage the PTO clutch control switch or lever.
3. Depress the clutch pedal fully.
4. Shift the shuttle shift lever to the neutral position.
5. Turn the key to "START" position.
6. The engine must not crank.
7. If it cranks, consult your local KUBOTA Dealer for this
service.
C Test: Switch for the operator's seat
1. Sit on the operator's seat.
2. Start the engine.
3. Engage the PTO clutch control switch or lever.
4. Stand up. (Do not get off the machine.)
5. The engine must shut off after approximately 1
second.
6. If it does not stop, consult your local KUBOTA Dealer
for this service.
(1) Battery terminals
(1) Hand throttle cable
(2) Foot throttle cable
(1) Shuttle shift lever
(2) Clutch pedal
(3) PTO clutch control lever
To Next Page
Loading...
Need help?
General
