Kubota M7060 User Manual

PERIODIC SERVICE92
BChecking Tie-rod Dust Cover
1. Check to see that dust covers are not damaged.
2. If dust covers are damaged, consult local KUBOTA
Dealer for this service.
A If dust covers are cracked, water and dust invade into
tie-rod and it will be early wear.
EVERY 100 HOURS
BLubricating Grease Fittings
Apply a small amount of multipurpose grease to the
following points every 100 hours:
If you operated the machine in extremely wet and muddy
conditions, lubricate grease fittings more often.
(1) Dust cover
(1) Grease fitting (Knuckle shaft) [RH, LH]
(1) Grease fitting (Front axle support)
(1) Grease fitting (Front axle support)

Kubota M7060 Specifications

General

Engine Type	Diesel
Horsepower	71 HP
PTO Horsepower	64 HP
Cylinders	4
Hydraulic System	Open Center
3-Point Hitch	Category II
Drive	4WD
Gears	12 Forward / 12 Reverse
Lift Capacity	3307 lbs
Displacement	148.5 cu in
Height	96.5 in (245 cm)