EasyManuals Logo

Kubota M7060 User Manual

Kubota M7060
145 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
OPERATING THE TRACTOR32
BTravel Speed Limiter
With the 6-speed main gear shift type, the highest travel
speed is reachable when the engine rpm is at around the
middle level with the maximum travel speed range. This
provides for a fuel-efficient run while traveling along
roads, pulling a trailer, etc. Step on the foot throttle, and
the engine rpm rises proportionally and the travel speed
goes up accordingly. But the engine speed is limited to
1960 rpm or so, and it does not increase even if the foot
throttle is increased.
When the main gear shift lever is set to the H-6 position,
the Rev-Limiter indicator illuminates.
BMain Gear Shift Lever
The main gear shift is fully synchronized to shift without
stopping.
A The main gear shift may be shifted between speeds
on-the-go, but the clutch must be depressed.
BRange Gear Shift Lever
The range gear shift can only be shifted when the tractor
is completely stopped and the clutch is depressed.
A To avoid transmission damage, depress clutch pedal
and stop the tractor before shifting between ranges.
BHydraulic-Shuttle Shift Lever
Raise up and shift the shuttle shift lever forward to obtain
forward speeds and shift back to obtain reverse speeds.
This shifting does not require clutch operation.
A The hydraulic-shuttle shift lever may be shifted while
the tractor is moving slowly.
A While the shuttle shift lever is at the "NEUTRAL"
position, the "N" character appears on the LCD
monitor.
BCreep Speed (if equipped)
Shift the range gear shift lever to to obtain low
speeds.
This shifting requires clutch operation.
C Creep speed should be used only when doing one
of the following jobs:
1. Deep rotary-tilling and harrowing
2. Planting
3. Turf application
C Creep speed can not be used for any of the
followings:
1. Pulling a trailer
2. Front-loader operation
3. Front-blade operation
4. Earth-moving
5. Entering and leaving a field
6. Loading onto and unloading from a truck
(1) Rev-limiter indicator
(N) "NEUTRAL"
(1) Range gear shift lever ...Creep ON

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota M7060 and is the answer not in the manual?

Kubota M7060 Specifications

General IconGeneral
Engine TypeDiesel
Horsepower71 HP
PTO Horsepower64 HP
Cylinders4
Hydraulic SystemOpen Center
3-Point HitchCategory II
Drive4WD
Gears12 Forward / 12 Reverse
Lift Capacity3307 lbs
Displacement148.5 cu in
Height96.5 in (245 cm)

Related product manuals