EasyManuals Logo

Kubota M8540 User Manual

Kubota M8540
111 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #102 background imageLoading...
Page #102 background image
PERIODIC SERVICE82
7. Fill with the new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See "LUBRICANTS" in "MAINTENANCE" section.)
8. After running the engine for a few minutes, stop the
engine and check the oil level again; add oil to
prescribed level.
9. Make sure that the transmission fluid doesn't leak past
the seal on the filters.
A To prevent serious damage to the hydraulic system,
use only a KUBOTA genuine filter.
A Do not operate the tractor immediately after changing
the transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
BChanging Front Differential Case Oil
1. To drain the used oil, remove the drain and filling plug
at the front differential case and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plug.
3. Remove the oil level check plug.
4. Fill with the new oil up to the lower rim of check plug
port.
(See "LUBRICANTS" in "MAINTENANCE" section.)
5. After filling reinstall the filling plug and check plug.
Oil capacity 60 L (63.4 U.S.qts.)
(1) Gauge
(2) Oil inlet
(A) Oil level is acceptable within this range
Oil capacity 6 L (6.3 U.S.qts.)
(1) Drain plug
(2) Filling plug
(3) Check plug

Table of Contents

Other manuals for Kubota M8540

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota M8540 and is the answer not in the manual?

Kubota M8540 Specifications

General IconGeneral
Engine TypeDiesel
Engine ModelKubota V3800-DI-T
Engine Power85 hp
PTO Power72 HP
Drive4WD
Hydraulic SystemOpen Center
3-Point HitchCategory II
Displacement230 cu in (3.8 L)

Related product manuals