Remove the flywheel.
Inspect each roller for wear or damage.
INSTALLATION
Install the starter driven gear onto the
crankshaft.
Install the starter idle gear and shaft.
FLYWHEEL INSTALLATION
Install the flywheel onto the crankshaft by
aligning the key on the crankshaft with the
groove in the flywheel.
Hold the flywheel with the flywheel holder
and tighten the flywheel nut.
Torque: 34.3_ 39.2N-m
• Before installation, check and make
sure that the inside of the flywheel is
not contaminated.
To Next Page
Need help?
General