KYMCO DINK 200 User Manual

4. LUBRICATION SYSTEM
4-6
DINK 200
Screw
Bolts
Oil Separator Cover
Pump Driven Gear
Bolt
Install the pump cover by aligning the hole in
the cover with the dowel pin.
Tighten the screw to secure the pump cover.
Make sure that the pump shaft rotates freely
without binding.
OIL PUMP INSTALLATION
Install the oil pump and oil separator and
tighten the two bolts.
Make sure that the pump shaft rotates freely.
The arrow of oil pump is upside.
Install the pump drive chain and driven gear,
then set the circlip securely on the pump
shaft.
Install the oil separator cover properly.
Install the A.C. generator starter driven gear.
(

10-5)
Circlip
Fit the tab of the separator cover into the
slit in the separator.
°Ø
Oil Separator
Pump Drive Chain
Arrow Mark

KYMCO DINK 200 Specifications

General

Brand	KYMCO
Model	DINK 200
Category	Scooter
Language	English