KYMCO DINK 200 User Manual

12. COOLING SYSTEM
12-15
DINK 200
THERMOSENSOR
THERMOSENSOR REMOVAL
Remove the seat, met-in box and center
cover.
Drain the coolant.
Disconnect the thermosensor wire.
Remove the thermosensor.
THERMOSENSOR INSPECTION
Suspend the thermosensor in a pan of water
over a burner and measure the resistance
through the sensor as the water heats up.
Temperature(℃ )
50
80
100
120
Resistance(Ω)
154
52
27
16
THERMOSENSOR INSTALLATION
Apply 3-BOND No. 1212 sealant or
equivalent to the thermosensor threads and
install it into the thermostat housing.
Connect the thermosensor wire.
Fill the radiator with coolant. (

3-9)
Install the center cover, met-in box and seat.
(

2-3)
Be sure to bleed air from the cooling
system.
＊
Thermosensor
Thermosensor Wire
Thermosensor
Thermometer
Thermosensor
Thermosensor Wire

KYMCO DINK 200 Specifications

General

Brand	KYMCO
Model	DINK 200
Category	Scooter
Language	English