19. EVAPORATIVE/EXHAUST EMISSION
CONTROL SYSTEM
CHARCOAL CANISTER
REMOVAL
1. Remove the frame right side cover.
2. Disconnect the charcoal canister tubes
that go to the fuel tank and purge
control valve.
3. Remove the charcoal canister.
INSPECTION
1. Plug the tube that goes to the fuel tank
and plug the blow-by tube. Then
connect a hose to the canister. Blow the
hose with mouth. The charcoal
canister is normal if air can be blown
into it. If clogged, replace it with a
new one.
2. Check the charcoal for cracks and
replace if necessary.
INSTALLATION
Install the charcoal canister in the reverse
order of removal.
The charcoal canister must be installed
to its original position to avoid
affecting its performance.
• Do not bend, twist or kink the tubes
during installation.
Valve
To Next Page
Loading...
Need help?
General
