Communication manual 8400 motec PROFIBUS
Safety instructions
General safety and application instructions
12 L EDS84DMOTPBUS EN 3.0 - 11/2011
2 Safety instructions
2.1 General safety and application instructions
Lenze drive and automation components ...
– must only be used as directed.
Application as directed
( 14)
– must never be commissioned in the event of visible damage.
– must never be technically modified.
– must never be commissioned before they have been completely mounted.
– must never be operated without the covers required.
– can - depending on their degree of protection - have live, movable or rotating parts
during and after operation. Surfaces can be hot.
For Lenze drive components ...
– use only the accessories approved.
– use only original spare parts from the manufacturer.
Observe all specifications given in the attached and associated documentation.
– This is the precondition for safe and trouble-free operation and for achieving the
product features specified.
Features and variants
( 15)
– The procedural notes and circuit details described in this document are only
proposals. It is up to the user to check whether they can be adapted to the particular
applications. Lenze does not take any responsibility for the suitability of the
procedures and circuit proposals described.
Note!
Always observe the specified safety measures to avoid severe injury to persons
and damage to property!
Always keep this documentation to hand in the vicinity of the product during
operation.
Danger!
If you disregard the following basic safety measures, this can cause severe injury
to persons and damage to material assets.
To Next Page
Loading...
Need help?
General
