EDS84DMOTPBUS EN 3.0 - 11/2011 L 13
Communication manual 8400 motec PROFIBUS
Safety instructions
Device- and application-specific safety instructions
Only qualified personnel may work with and on Lenze drive and automation
components. According to IEC 60364 and CENELEC HD 384, these are persons ...
– who are familiar with the installation, assembly, commissioning and operation of
the product.
– who have the corresponding qualifications for their work.
– who know all regulations for the prevention of accidents, directives and laws
applicable on site and are able to apply them.
2.2 Device- and application-specific safety instructions
During operation, the communication unit must be connected to the wiring unit and
the drive unit.
With external voltage supply, always use a separate power supply unit, safely
separated to EN 61800-5-1 in every control cabinet ("SELV" / "PELV").
Only use cables that correspond to the given specifications.
Bus cable specification
( 25)
2.3 Residual hazards
Device protection
The communication unit contains electronic components that can be damaged or
destroyed by electrostatic discharge.
Installation
( 20)
Documentation for "Inverter Drives 8400 motec", control system, system/
machine
All other measures prescribed in this documentation must also be implemented.
Observe the safety instructions and application notes specified in the
documentation.
To Next Page
Loading...
Need help?
General
