Action Yes No
Step 3
a Check the toner cartridge contacts for contamination.
b Check the toner cartridge for leaks and damage.
Are the toner cartridge and its contacts free of contamination and
damage?
Go to step 5. Go to step 4.
Step 4
Clean or replace the toner cartridge.
Does the problem remain?
Go to step 5. The problem is
solved.
Step 5
a Check the toner cartridge smart chip contacts for
contamination.
b Check if the contacts are bent or damaged.
Are the contacts free of contamination and damage?
Go to step 7. Go to step 6.
Step 6
Clean, repair, or replace the smart chip contact. See
“Toner
cartridge smart chip contact removal” on page 195.
Does the problem remain?
Go to step 7. The problem is
solved.
Step 7
Reseat the smart chip contact cable on the controller board.
Does the problem remain?
Go to step 8. The problem is
solved.
Step 8
Check the sensor (cartridge barrel) and its actuator for damage and
misalignment.
Are the sensor and its actuator properly installed and free of
damage?
Go to step 10. Go to step 9.
Step 9
Replace the sensor. See
“Cartridge barrel shutter sensor kit
removal” on page 198.
Does the problem remain?
Go to step 10. The problem is
solved.
Step 10
Reseat sensor cable from the controller board.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
4600-830, -835, -895
Diagnostics and troubleshooting
104