140 errors
140 error messages
Error code Description Action
140.81 Motor (main) does not turn o. See
“Main drive failure service check” on
page 120.
140.82 Motor (main) speed did not ramp up to the
required level.
140.83 Motor (main) stalled.
140.84 Motor (main) ran too slow.
140.85 Motor (main) ran too fast.
140.86 Motor (main) did not run at the correct timing.
Main drive failure service check
Action Yes No
Step 1
a Remove the left cover. See “Left cover removal” on page
177.
b Remove the right cover. See “Right cover removal” on
page 186.
c Reseat the cable from the main drive gearbox and the controller
board.
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
a Enter the Diagnostics menu, and then navigate to:
Printer diagnostics and adjustments > Motor tests >
Transport
b To uc h Start.
Does the motor run?
Contact the next
level of support.
Go to step 3.
Step 3
Check the motor and its gears for misalignment, wear, and
damage.
Is the main drive gearbox properly installed and free of wear and
damage?
Contact the next
level of support.
Go to step 4.
Step 4
Reinstall or replace the main drive gearbox. See
“Main drive
gearbox removal” on page 178.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
4600-830, -835, -895
Diagnostics and troubleshooting
120