LG MultiV Series User Manual

Owner’s & Installation Manual 53
ENGLISH
52 New Wide Wired Remote Controller
Owner's Instructions
Programming - Simple Reservation
Press button to enter the
Programming mode.
(the segment flashing)
Ex) Setting Simple Reservation
time as '3'.
1
Press button to adjust reservation
time.
2
Press button to finish setting.
3
Pressing the button will exit the
settings mode. If is not pressed, the
remote controller will automatically exit
setup mode after 25 seconds with no
input. If the set button is not pressed, the
changes will not take effect.
4
You can set the reservation conveniently in the units of 1 hour from 1 hour to 7 hours.
C When simple reservation setup, product automatically runs or stops after the time that is set.
Owner's Instructions
Function Setting – WLAN(Wireless LAN) Module Access Point mode
Push the button repeatedly until the
term of 'AP' is displayed on the screen.
1
Press the button.
❈ After setup, it automatically gets out
of setup mode.
2
While WLAN module is operating in
access point mode, the term of 'AP'
blinks on the screen of cable remote
control.
- It will take approx. five (5) seconds
before WLAN module operates in
access point mode.
- In the case WLAN module is not
installed, the access point mode does
not work.
3
It is the function to operate WLAN (Wireless LAN) module connected to the product in access point
mode. This functionisavailable for particular models toapply WLAN Module.
Refer to the installation manual of productwhether available or not.

LG MultiV Series Specifications

General

Brand	LG
Model	MultiV Series
Category	Remote Control
Language	English