Owner’s & Installation Manual 55
54 New Wide Wired Remote Controller
Owner's Instructions
Programming - ON Reservation
Press button.
Ex) Setting ON Reservation
Time as 'AM 10:20'.
1
Press the button until the
ON segment flashes.
( segment flashing)
2
Press button to adjust AM/ PM
setting.
3
Press button to Hour setting
mode. When the Hour icon flashes, you
can set the time between 1-12.
4
Press button to shift to Minute
setting mode. When the Minute icon
flashes, you can set the time between
00-59.
5
Press button to finish setting.
6
Automatically turned On at reserved time that you set.
Owner's Instructions
Programming - Sleep Reservation
Press button to enter the
Programming mode.
Ex) Setting Sleep Reservation
time as '3'.
1
Press the button until the
segment flashes.
2
Press button to adjust reservation
time.
The SLEEP reservation time is from 1 to
7 hours.
3
Press button to finish setting.
Whenever reservation is done.
4
Pressing the button will exit the
settings mode. If is not pressed, the
remote controller will automatically exit
setup mode after 25 seconds with no
input. If the set button is not pressed, the
changes will not take effect.
5
If finishing sleep reservation setup,
air-conditioner product operates sleep
drive and stops after the time that is set.
6
Sleep reservation is the function of air-conditioner to run and stop after a certain period of time at
sleep mode before sleep. When connected to a ventilation product and set the sleep reservation,
when it goes to the sleep mode, after the set time has elapsed.
Please reserve proper time at sleeping. (Too much air-cooling is not good for your health.)
• Because it automatically adjusts desired temperature for comfortable air-cooling at sleep drive,
there could be difference between remote controller's desired temperature and air-conditioner
body's desired temperature.
• Sleep reservation operates as off reservation for the product whose temperature adjustment is not
controlled by unit of 0.5℃(1℉).
To Next Page
Loading...
Need help?
General
