110
ENGLISH
Sound Problems
First of all, perform a (Q. Settings) Sound Sound Test to check
for any abnormalities in the projector.
If you are using a set-top box, turn it off, and then turn it back on.
Make sure that the set-top box is correctly connected to your projector.
The screen is ne, but it does not play any sound.
• Try another channel.
• (Q. Settings) Sound Sound Out
Check whether the Sound Out is set to Internal Projector Speaker.
If you use a set-top box, there will be no sound if you have set the volume of
the set-top box or your projector to 0 or enabled Mute. Set the volume to an
appropriate level.
The stereo sound is not clear on an analog channel, or there is no sound from
one of the speakers.
• Applies only in countries where sound multiplex broadcasting is available.
Wheel (OK) or OK
Select MONO in Multi Audio if you are out of range or sound multiplex
broadcasting is not stable.
• (Q. Settings) Sound Sound Mode Settings Balance
Adjust the balance as necessary with the Navigation button in Balance.
The TV sound is not synchronized with the picture, or the sound sometimes
breaks up.
• If this happens on only some of the channels, it may be caused by the
broadcasting company’s transmission signal. Please have your broadcasting
services provider (wired/cable) diagnose the problem.
• If all channels are out of sync, go to (Q. Settings) Sound AV
Sync Adjustment and adjust the sync.
To Next Page
Loading...
Need help?
General
