Installation
5
2.0 INSTALLATION
2.1 Install a Liebert IntelliSlot Web Card—Non-Adapter Version
Follow these steps to install a Liebert IntelliSlot Web card (non-adapter version—P/N IS-WEBCARD,
IS-WEBLB, IS-WEBLBDS, IS-WEBNXL, IS-WEBL, IS-IPBML, IS-WEBS and IS-IPBMS).
1. Locate the Liebert IntelliSlot option bay on your Liebert equipment—You might need to remove a
plastic cover.
2. Insert the Liebert IntelliSlot Web Card into the Liebert IntelliSlot bay.
3. Secure the card with the supplied screws.
4. Connect an Ethernet cable.
DHCP: The card ships with DHCP service enabled. The MAC address is on a
sticker on the top of the card.
OR
Static IP: To assign a static IP address or hostname, use terminal emulation
software to configure the card, as described in Sections 2.1.1 and 2.1.2.
2.1.1 Connect the Cable
• Connect a configuration cable (null modem) to the DB-9 port on the card and to
a COM port on your PC. The configuration cable is available separately from
Emerson (P/N LIEBNULL).
2.1.2 Prepare the Card for Configuration
• Use terminal emulation software, such as
Microsoft
®
HyperTerminal, to open a
connection to the card with the settings in
Table 3.
• Press the Enter key for the Main Menu, above
right.
• Select IP Network Settings, then Boot/IP
Settings and follow the instructions to enter
an IP ADDRESS, NETMASK and GATEWAY.
• Press Esc to return to the Main Menu.
• Choose Exit and Save to save your changes
and reboot the card.
WARNING
Only a qualified service professional should install these products. Emerson recommends
having a Liebert Services representative perform the installation in large UPSs. Contact
Liebert Services at 1-800-LIEBERT (1-800-543-2378).
Table 3 Communication settings
Baud Rate: 9600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
NOTE
When installing the card in a Liebert NX,
configure the communication port of the
Liebert NX to 2400 baud. See the Liebert
NX user manual for details.
To Next Page
Loading...
Need help?
General
