Liebert IntelliSlot Installation Manual

Network Settings
35
5.8 Reset WEB Authentication to Factory Defaults (Units with IS-WEBCARD, IS-WEBL,
IS-IPBML, IS-WEBS, IS-IPBMS, IS-WEBLB, IS-WEBNXL Cards Only)
You may reset the Administrator and General User usernames and passwords to the factory defaults.
This option applies only to the following cards:
• IS-WEBCARD
•IS-WEBL
•IS-IPBML
•IS-WEBS
•IS-IPBMS
•IS-WEBLB
• IS-WEBNXL
If you forget your username or password, you may reset them using a serial configuration cable
connection (see Section 2.1.1 or 2.2.1 - Connect the Cable), which provides direct access to the card
without a username or password. To enter a new username and password, see 5.7 - Change
Username / Password - Administrator and General User.
Terminal Emulation (Serial or TCP/IP Connection) / Telnet
To reset the usernames and passwords to the factory defaults:
1. Choose IP Network Settings from the Main Menu, then
Reset WEB Authentication to Factory Defaults.
2. Enter y to reset the Administrator and General User
usernames and passwords to the default settings.
Web Interface
Table 18 Factory default passwords
Type of User Factory Default Description
Administrator
Username Liebert
Full access to configuration and control
functions, as well as viewing privileges
Password Liebert
General User
Username User
Viewing privileges only—no access to
configuration or control functions
Password User
NOTE
This feature is not available through the Web interface.
IP Network Settings Menu
-------------------------
1: Boot/IP Settings
2: Domain Name Server (DNS) Settings
3: Management Protocol
4: Web Server
5: Telnet Server
6: Time (SNTP)
7. Change Administrator Username/
Password
8: Change General Username/Password
9: Reset WEB Authentication to Factory
Defaults
<ESC>: Cancel menu level
Please select a key ?>9
Reset WEB Authentication to Factory
Defaults? [y/n] ?>

Liebert IntelliSlot Specifications

General

Brand	Liebert
Model	IntelliSlot
Category	Network Card
Language	English