Configuration Overview
12
3.6 Saving Changes and Reinitializing the Web Card
Follow the applicable steps for your interface to save configuration changes and reinitialize the Web
card. Changes will not take effect until these steps are completed.
Terminal Emulation (Serial or TCP/IP Connection) / Telnet
• After each change is made, a reminder appears (shown at right).
• Return to the Main Menu, then choose Exit and Save. A
message appears and remains until the card is reinitialized,
followed by a message that the process was successful.
Web Interface
• After making each change, click the Save button. A reminder
appears each time you make a change (shown at right).
• Without leaving the Configure tab window (below left), click
Reinitialize in the left panel, then click the Reinitialize
button at right to reboot the Web card and put your changes
into effect.
• A message window appears, shown above right, and remains until the card is reinitialized.
New Settings will take effect
when saved
GO TO MAIN MENU AND DO 'EXIT AND
SAVE' TO SAVE YOUR CHANGES!
Exiting and saving...
Configuration saved successfully
First click
Reinitialize
at left
Then click
Reinitialize
button
Progress message window
To Next Page
Loading...
Need help?
General
