EasyManuals Logo
Home>Liebert>Network Card>IntelliSlot

Liebert IntelliSlot Installation Manual

Liebert IntelliSlot
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
Network Settings
18
5.3 Management Protocol
The Management Protocol Menu allows you to enable or disable SNMPv1/v2c and SNMPv3 and
configure management protocols. Consult your network administrator for these settings.
See Section 10 for Management Protocol options for BACnet and Modbus.
Terminal Emulation (Serial or TCP/IP Connection) / Telnet
To change any parameter:
1. Choose IP Network Settings from the Main Menu, then
Management Protocol.
2. Select an option to change, then use the following guide to
make changes.
Web Interface
To access SNMP Protocol settings through the Web interface:
Click on the Configure tab, then SNMP (under Management Protocol) in the left panel and
finally Edit in the right panel. After making changes, click Save.
NOTE
SNMP v3 is available for IS-WEBCARD (HID9) only.
Table 12 Management protocol ranges
Parameter Description & Telnet Menus
SNMP Protocol
Enable or disable SNMPv1/v2c or
SNMPv3 for remote management.
SNMP
Communications
The SNMP Communications Menu
(shown at right) allows you to set up
access privileges and configure the Web
card to send traps for SNMPv1/v2c and
SNMPv3.
Refer to 5.3.1 - SNMP Communications
Menu and Table 13 in that section for
details and additional references to more
information on these options.
Management Protocol Menu
-------------------------
1: SNMPv1/v2c Protocol enabled
2: SNMPv3 Protocol enabled
3: SNMP Communications
<ESC>: Cancel menu level
Please select a key ?>
Enable SNMPv1/v2c Protocol? [y/n] ?>
Enable SNMPv3 Protocol? [y/n] ?>
SNMP Communications Menu
-------------------------
1: Authentication Traps yes
2: RFC-1628 (UPS) MIB enabled
3: - Traps enabled
4: Liebert Global Products MIB enabled
5: - Condition Traps enabled
6: - System Notify Trap enabled
7: Heartbeat Trap Interval 24 hours
8: Display/Modify SNMPv1/v2c Communities
9: Display/Modify SNMPv1/v2c Trap Communities
A: Display/Modify SNMPv3 Settings
B: Support Information
<ESC>: Cancel menu level
Please select a key ?> 1
SNMP
Configure
tab
Click on Edit

Table of Contents

Other manuals for Liebert IntelliSlot

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Liebert IntelliSlot and is the answer not in the manual?

Liebert IntelliSlot Specifications

General IconGeneral
BrandLiebert
ModelIntelliSlot
CategoryNetwork Card
LanguageEnglish

Related product manuals