11. Appendix MMX4x2 series – User's Manual 162
Content of Backup File
to a device, the following will be overwritten:
Autoselection (mode, port priority, delay)
HDMI output ports
Test pattern mode, clock source, and type
Analog audio ports
Local and TPS serial port
RS-232 mode, Control protocol, Baud rate, Data bits, Stop bits, Parity
Port name and CI (Command Injection) port number
Local and TPS IR port
Input port name, Output port name
Saved IR codes, names
Network settings
Static IP address, Network mask, Gateway address
Further settings
Control lock status, Device label, Dark mode state
User EDID data (U1-U14), Emulated EDIDs by ports
Crosspoint presets (1-4)
Event manager: settings of all Events (E1-E100)
Factory Default Settings
Parameter
Video crosspoint settings
O1 (HDMI out 1) - MMX4x2-HDMI I1 (HDMI in 1)
O1 (HDMI out 1) - MMX4x2-HT200 I1 (TPS in 1)
O2 (HDMI out 2) - for both models I2 (HDMI in 2)
Audio crosspoint settings
O1 (HDMI out 1) A1 (original HDMI embedded audio)
O1 (HDMI out 1) A2 (original HDMI embedded audio)
O3 (Audio out) A3 (analog audio input)
Video input port settings
TPS mode * Auto
HDCP Enabled
Test pattern mode Disabled
Test pattern clock source 480p
Test pattern Bar
Video output port settings
Autoselect feature Disabled
Autoselect mode Priority detect
Signal type Auto
HDCP mode Auto
Always on
Emulated EDID on all four inputs Factory #47: Universal HDMI PCM
Analog audio input port settings
0.00 dB (100%)
Balance 0 (center)
Gain 0.00 dB
Analog audio output port settings
0.00 dB (100%)
Balance 0 (center)
Network settings
IP address 192.168.0.100
Subnet mask
Static gateway 192.168.0.1
DHCP Disabled
To Next Page
Loading...
Need help?
General
