D9U003VC0-0101_0512
2.1 Before use
It is necessary to read the instructions for use before operating the mattress system.
Follow the instructions carefully.
Use the mattress system only as specied in this manual.
LINET shall not assume any responsibility for any damage or injury resulting from incorrect use.
Position the power cord so that there are no loops or kinks in the cable; protect the cable from mechanical wear and tear. Impr-
oper handling of power cord can cause an electric shock hazard, other serious injuries or damage to the mattress system.
Position the power cord so there is no risk of injuring the patient (e.g. choking hazard).
Regular inspection of the mattress interior to be carried out on a regular basis.
In case of any problem please contact manufacturer for help at installation, service or if an unexpected event occurs.
2.2 Installation
Ensure that installation is performed in accordance with the instructions in this manual.
Ensure that maintenance is performed only by qualied personnel who have been trained by the manufacturer.
2.3 Usage
Ensure that the mattress system is only operated by suitably qualied personnel or after receiving instruction from them.
Only use the mattress system if it is in perfect working order.
Only use the system in clean environment.
Always hold SCU with scoop handle when moving.
Only use the mattress system with the correct power supply (see Electromagnetic Compatibility).
Replace any damaged parts immediately with original spare parts only.
Do not exceed the maximum patient weight (see Mechanical Specications).
Do not use the SCU in near ammable gases. This does not apply to oxygen cylinders.
Do not cover SCU while in use.
Do not place SCU near extreme heat sources such as radiators.
Never handle the power plug with wet hands.
Disconnect the product from the outlet only by pulling the power plug. While pulling the power plug, always hold the actual
plug, not the cord.
Mattress and SCU must be checked at least once a day. Check that:
the mattress is inated to the required pressure
the Low Pressure indicator is not pernamently illuminated
in case of error refer to the chapter “System Faults”
The handles located on the both sides of the mattress cover are designed only for manipulation with the mattress without load
(without patient).
To Next Page
Loading...
Need help?
General
