LINET CliniCare 100 HF User Manual

D9U003VC0-0101_0520
6 Use and Storage Conditions
DANGER!
Risk of injury due using CliniCare 100 HF system in incorrect environments!
► Never use or store CliniCare 100 HF system in environments which contains ammable gases (except oxygen
cylinders).
6.1 Storage
CAUTION!
Incorrect storage can damage the mattress!
► Do not store mattress in compressed state (e.g. underneath other mattresses) or rolled state for long periods of
time as this may a󰀨ect the performance of the air/foam cells.
When SCU is not in use:
► Switch o󰀨 SCU using power switch on the control panel of SCU.
► Unplug power cord.
► Wrap power cord around SCU.
► Pack in suitable cover.
► Store in a place suitable for electronic medical devices.
When mattress is not in use:
► Store at, unfolded and in dust proof bag.
► Store in a place suitable for medical devices.
► The most convenient storage: vertical
7 Scope of Delivery and Bed Variants
7.1 Delivery
■ Upon receipt, check that the shipment is complete as specied on the delivery note.
■ Notify the carrier and supplier about any deciencies or damages immediately as well as in writing or enter them on the
delivery note.
7.2 Contents
There are two versions of CliniCare 100 HF. Check the table below to recognize your version.
CliniCare 100 HF with MCM mode:
■ Mattress with cover with MCM layer – CliniCare 100
HF
□ 3 air connectors
■ SCU (System Control Unit) with hose – Applied part
type B
□ STATIC and APT+MCM modes
■ Instructions for use
CliniCare 100 HF without MCM mode:
■ Mattress with cover – CliniCare 100 HF
□ 2 air connectors
■ SCU (System Control Unit) with hose – Applied part
type B
□ STATIC and APT modes
■ Instructions for use

LINET CliniCare 100 HF Specifications

General

Brand	LINET
Model	CliniCare 100 HF
Category	Medical Equipment
Language	English