Rev: 11.08.19 Page 113 CCD-0001573-08
Introduction
This product is a 3 in 1 manual override handle for your tongue jack or stabilizer system. The three options
are ¾” hex override,
⁄
” hex override, and pin override (as seen on the PSX1). The ¾" socket can be used
on tongue jacks and scissor jacks. The
⁄
" socket is intended for PSX2, and the pin override is intended for
PSX1.
Safety
Read and understand all instructions before starting any procedures stated in this manual. Adhere to all
safety labels to prevent personal injury and/or product damage. Failure to follow instructions and safety
labels may void product warranty.
The "WARNING" symbol above is a sign that a procedure has a safety risk involved and may cause
death or serious personal injury if not performed safely and within the parameters set forth in this
manual.
Failure to follow instructions provided in this manual may result in death, serious personal injury
and/or severe product and property damage, including voiding of the component warranty.
Trailer MUST be supported per manufacturer's recommendations before working underneath.
Failure to do so may result in death or serious personal injury.
Moving parts can pinch, crush or cut. Keep clear and use caution.
Preparation
1. Applicable tongue jack or stabilizer owner's manual with operation, override and troubleshooting
instructions.
2. Frame supports as per manufacturers recommendations.
Manual Override
Most stabilizers and tongue jacks come equipped with a manual override system.
NOTE: The manual override procedure must be performed individually on each motor of PSX2 in order to
manually extend or retract the stabilizer legs.
LEVELING AND STABILIZATION
MANUAL OVERRIDE WRENCH
To Next Page
Loading...
Need help?
General
