Lippert Components PSX2 User Manual

Rev:11.08.19 Page 99 CCD-0001573-08
Troubleshooting
Error Display In LCD Screen
Faults can only be cleared via the OneControl™ Touch Panel or OneControl™ Leveling App through myRV®.
The only exception is when the Auto Leveling Control mini-touch pad (Fig. 1) was used to abort an auto-
sequence. In this case the fault can be cleared by pressing any Auto Leveling Control button.
LCD Message What's Happening? What Should I Do?
"EXCESS ANGLE"
Unsecured controller.
Uneven or sloped site.
Check and secure controller
placement.
Relocate the trailer.
"EXCESSIVE
ANGLE"
Controller not properly
secured.
Check and secure controller
placement.
Excessive angle reached
during manual operation.
Relocate the coach.
"BAD
CALIBRATION"
Trailer zero point was not set
correctly.
Reset zero point.
"FEATURE
DISABLED"
Hitch recognition requested
but no
hitch height set.
Perform "AUTO LEVEL" sequence to
establish hitch height.
Zero point not set. Set zero point.
"LOW VOLTAGE"
Bad connection or wiring.
Discharged or bad battery.
Check wiring - repair or replace.
Test battery voltage under load -
charge or replace.
"OUT OF
STROKE"
Unsecured controller.
Uneven or sloped site.
Check and secure controller
placement.
Relocate the trailer.
"EXTERNAL
SENSOR"
Bad connection or wiring.
Replace or repair connection to rear
remote sensor.
"JACK TIME OUT"
System could not level in
expected time.
Check for obstructions, leaks, fluid
level and voltage to power unit
motor under load.
"AUTO LEVEL
FAILURE"
Unsecured controller.
Voltage drop.
Check and secure controller
placement.
Test battery voltage under load -
charge or replace.
"FUNCTION
ABORTED"
User has aborted an
automatic leveling sequence.
Restart the sequence.

Lippert Components PSX2 Specifications

General

Brand	Lippert Components
Model	PSX2
Category	Lifting Systems
Language	English