4 -8
4-3. How to handle new tractor
(2) Notices in handling new tractor
z To get the best performance, comply with the following instructions.
- DO NOT start or stop the tractor suddenly.
- DO NOT carry out heavy loaded work and DO
NOT increase the engine rpm to high speed
suddenly.
- Despite warm temperature outside, carry out
warming up the engine for approximately 5
minutes at 1500 rev/min
(1) Check points
※ For new tractor, the followings must be checked once again even though there was sufficient quality
management, inspection, regulating of each part in the factory.
z Appearance check
- Is there any damage while transporting?
z Engine cooling system check
- Is there anti-freeze solution in the radiator? And any leakage?
z Fuel system check
- Is there any leakage of fuel in the fuel system?
z Oil level check
- Is there optimal oil amount in each part ?
z Electric system check
- Is there any cut-off or any other problem in the wiring?
- Is there any problem to operate the instruments?
- Is the state of battery charging sufficient?
z After using first 50 hours,
- Replace the engine oil filter and hydraulic oil filters after first 50 hours of work, and check each
part of your tractor as reference of chapter 5. “Lubrication and Maintenance” (See page 5-1.)
- If possible, contact your authorized dealer for “First 50 hour check”.
To Next Page
Loading...
Need help?
General
