4 -11
1. Press the clutch and brake pedals. Pull the
throttle lever to “Low speed” position. Place
the shuttle lever, main gear shift lever in
NEUTRAL and PTO switch to “OFF” position.
3. Apply parking brake and release the brake
pedals and clutch pedal slowly.
2. Lower the implements to the ground and
turn key switch to “OFF” position.
(5) Stopping tractor
Mechanical type
1. Release the HST forward/reverse pedal
slowly. Pull the throttle lever to “Low” speed
position. Place the range gear shift lever in
NEUTRAL and PTO switch to “OFF”
position.
3. Apply parking brake and release the brake
pedals slowly.
2. Lower the implements to the ground and
turn key switch to “OFF” position..
HST Type
Brake pedals
Clutch pedal
Throttle lever
Key switch
HST pedals
Throttle lever
Brake pedals
Parking brake lever
Key switch
Release
Parking brake lever
Brake pedals
PTO switch
PTO switch
Caution
▶ DO NOT leave the tractor with the transmission gear is placed in neutral position
and the parking brake not applied. The tractor may roll down.
Apply the parking brake at all times before leaving the tractor.
▶ Remove the ignition key always after stopping engine.
To Next Page
Loading...
Need help?
General
