5 -20
5-5. When the warning indicator lights
(1) Drain water from Fuel filter
1. Loosen the fuel filter sensor and drain water
inside of the filter. (Approx. 150cc(9.1 in³))
2. Tighten the drain plug and bleed the air from the
fuel filter. (See page 5-49)
Fuel filter
warning indicator
▶Do not throw the exhausted waste fuel to any place. This may pollute the soil and
water seriously and also is prohibited legally. If violating, you would be responsible
for that by civil or criminal case. The waste oil must be disposed according to the
environment laws.
Caution
▶ Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire.
To help prevent possible injury, turn the key switch off when changing fuel filters or
water separator elements. Clean up fuel spills immediately.
Warning
▶ Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel
system component that will be disconnected. Fit a suitable cover disconnected fuel
system component. Do not fill the new filter with fuel. Invisible fine contaminants
can enter the injection pump and it may cause damage to the fuel injection system.
Caution
Fuel filter sensor
Main fuel filter
Air bleed plug
To Next Page
Loading...
Need help?
General
