3 -23
Cruise control switch
(16) Cruise control switch (HST type)
(17) HST forward / reverse pedal
(HST type)
Press down the HST forward pedal slowly in
order to move the tractor forward, and if
releasing the pedal, it returns back to the neutral
position, and the tractor stops.
The HST reverse pedal is operated in the same
way as the HST forward pedal.
To start the engine, these pedals must be placed
in the neutral position. For the details of the
engine start, see chapter 4-2-(1), “Engine start”
in this manual.
HST
reverse
pedal
HST
forward
pedal
▶DO NOT press the one-side brake pedal during the cruise drive. You must connect
the left and right brake pedal with the brake pedal latch before driving in order to
avoid a possible accident.
▶Do not operate the cruise control switch while driving backward.
Caution
This switch is used to set / release the cruise
control for HST type tractor.
- Cruise : Press the upper side of the switch
while driving forward.
- Release : Press the lower side of the switch to
stop the cruise control drive.
To stop the cruise drive, press down the both
brake pedals or lower side of the cruise control
switch. The forward pedal returns to the neutral
position and the cruise drive will be disengaged.
Warning
▶ When releasing the HST pedal while driving in high speed, the braking distance
can be extended depending on the load conditions. At this time, press down the
brake pedal(s) to stop the tractor.
▶ DO NOT operate the HST pedal hastily. It may cause a shock to you.
To Next Page
Loading...
Need help?
General
