Manitowoc Published 03-29-17, Control # 064-23 3-35
14000 OPERATOR MANUAL OPERATING CONTROLS AND PROCEDURES
10. After engine is started, cab seat with handles appears as
shown in Figure 3-19
. Use display buttons to select the
crane configuration, then press Confirm button to select
configuration.
11. When crane configuration is selected, the information
screen appears with engine data box on right side and
previously selected items on the left side as shown in
Figure 3-41
.
12. Select crane configuration and capacity charts on Rated
Capacity Indicator/Limiter display, Configuration screen.
Load drums and hoist drums are inoperable until this
step is performed.
13. If equipped, an optional air temperature sensor monitors
ambient temperature in the left side enclosure
(Figure 3-20
).
When ambient air temperature of -22°F
(- 30°C) is reached, fault message #45
appears on the fault screen.
The crane’s software program will not
allow booming down or hoisting up until
ambient temperature is above -22°F (- 30°C).
If the electric cable is disconnected from the
temperature sensor, a terminator receptacle must be
connected to the cable to bypass the sensor; otherwise
the fault message above will appear on the fault screen.
FIGURE 3-19
14COM3-15
T Appears Here when Tandem
Drum Mode is Turned ON
T
FIGURE 3-20
Air
Temperature
Sensor
14COM3-6
To Next Page
Loading...
Need help?
General
