OPERATING CONTROLS AND PROCEDURES 18000 OPERATOR MANUAL
3-12
Published 12-05-17, Control # 032-23
FRONT WINDOW OPERATION
See Figure 3-3 for the following procedure.
Closing Window
Rotate window latch handle DOWN to position shown in
View A.
Opening Window For Ventilation
Rotate window latch handle UP to position shown in View B.
Window can be swung open approximately 3 in (76 mm) for
ventilation.
Opening Window For Emergency Exit
Pull out both quick-release pins at latch handle. Remove
both knobs at top of window (View C). Push window out to
allow emergency exit from cab.
CRANE ORIENTATION
The terms right, left, front, and rear used in this section
correspond to the operator's right, left, front, and rear sides
when seated in the operator's cab with the front of the
carbody to the operator’s front. The carbody and crawler
controls are mounted on the front of the carbody.
OPERATING CONTROLS
The purpose of the following instructions is to familiarize
qualified operators with the location and function of standard
and optional operating controls for this crane. This section
also contains safety information and a description of
operation for each crane function.
Depending on the options your crane is equipped with, some
controls identified in this section will not apply.
DISPLAY LANGUAGE
The language that is displayed on Rated Capacity
Indicator/Limiter (C1) and Digital Display (D4) can be
changed. See the Rated Capacity Indicator/Limiter
Manual for instructions.
WARNING
Prevent death or serious injury to personnel!
Read and thoroughly understand instructions in this
section, Section 2, and in Capacity Chart Manual.
Contact your Manitowoc dealer for assistance if any
operating procedure is not clearly understood.
FIGURE 3-3
P1751
View A
Handle
Quick-Release Pin
(both ends of handle)
P1750
View B
Handle
P1752
View C
(2 places at top of window)
Quick-Release Pin
(both ends of handle)
Knob
To Next Page
Loading...
Need help?
General
