National Crane 3-29-2018 Control # 610-00 11-1
NBT40-1 SERIES OPERATOR MANUAL SAFETY DECALS
SECTION 11
SAFETY DECALS
SECTION CONTENTS
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-1
Capacity Chart . . . . . . . . . . . . . . . . . . . . . . . . . . 11-1
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . 11-1
GENERAL
Capacity Chart
The capacity chart is stored in the crane’s operator control
station. The capacity chart contains lifting capacities of the
crane in all allowable lifting configurations.
Safety Information
Information regarding Safety, Operation and Specifications
Decals installation are included in the following section of
this manual.
You must read and understand operator manual and all
safety instructions.
It is the user’s responsibility to follow manufacturer’s
instructions on machine operation, application, and observe
pertinent laws and regulations and capacity charts before
operating machine.
The machine is provided with specific warning and
information signs.j
• Operating this equipment without all safety and control
decals in place can be hazardous. Do not remove the
signs.
• Refer to decals on equipment and operator manual for
proper setup.
• Ensure that all signs and labels are undamaged and
legible.
• Clean soiled labels with soap and water if necessary, do
not use fuel or solvents.
• Replace damaged, scratched or illegible signs and
labels.
• Signs and labels are available from Manitowoc
CraneCare (see Spare parts catalog).
To Next Page
Loading...
Need help?
General
