CHAPTER 10: MYA-MINA/LINA MOUNTING YOKE
54
MYA-MINA/LINA FLOWN CONFIGURATIONS
The MYA-MINA mounting yoke flies up to three LINA loudspeakers from a single hanging point. The yoke attaches to the
side brackets (which attach directly to the LINA end frames) and is secured with the included M6 screws in the center pivot
holes, and the M6 knobs in one of three pinning holes. For flown applications, the yoke supports up to 20 degrees of uptilt
and severe downtilts of 90 degrees or more (Figure 46).
CAUTION: The MYA-MINA/LINA mounting bracket at the top of yoke has one 1/2-inch center hole and four
smaller corner holes. Only the center hole is rated for flown applications. The four corner holes are used for
attaching to pole-mount adapters. For information load ratings, see Table 9 on page 52.
Figure 46: Flown Configurations for MYA-MINA/LINA with Three LINAs
Figure 47: Flown MYA-MINA/LINA with MPA-3 Adapter and Three LINAs
To Next Page
Loading...
Need help?
General
