Miele DGC 735 Series User Manual

Installation
*INSTALLATION*
114
Installing the steam
combination oven
For safety reasons, the steam
combination oven may only be used
when it has been fully installed.
The steam combination oven
requires a sufficient supply of cool air
for efficient operation. The required
supply of cool air must not be
excessively heated by other heat
sources (e.g. solid fuel stoves).
The following must be observed
when installing the appliance:
Make sure that the interim shelf that
the steam combination oven sits on
does not touch the wall.
Do not fit heat insulation strips to the
side walls of the housing unit.
 Connect the steam combination oven
to the electrical supply.
Carrying the steam combination
oven by the door handle could
damage the door.
Use the handle cut-outs on the side
of the housing to lift the appliance.
It is a good idea to remove the door
(see "Cleaning and care – Removing
the door") and the accessories before
installing the appliance. The steam
combination oven is then easier to
push into the housing unit and you do
not run the risk of lifting it by the door
handle.
 Push the steam combination oven
into the housing unit and align it.
 Open the door, if you have not
removed it.
 Use the screws supplied to secure
the steam combination oven to the
side walls of the housing unit.
 Refit the door, if necessary (see
"Cleaning and care – Fitting the
door").

Miele DGC 735 Series Specifications

General

Brand	Miele
Model	DGC 735 Series
Category	Oven
Language	English