Cleaning and care
90
Removing stubborn soiling
(excluding the FlexiClip
telescopic runners)
Spilled fruit and roasting juices may
cause lasting discolouration or matt
patches on surfaces. This
discolouration will not affect the
functional characteristics of the
surface finish.
Do not attempt to remove these
marks. Clean them following the
instructions given here.
Baked-on deposits can be removed
with a glass scraper or with a
stainless steel spiral pad, hot water
and washing-up liquid.
Useful tip: Cleaning is made easier
when you use the Other |
Maintenance| Soak programme (see
"Maintenance").
Exposure to scouring agents,
abrasive brushes or sponges and
oven sprays can cause catalytic
enamel to lose its self-cleaning
properties.
Remove the catalytic enamelled
panels before using an oven cleaner.
Using oven cleaners
Very stubborn soiling on PerfectClean
surfaces can be cleaned using Miele
Oven Cleaner. This cleaner must only
be applied to cold surfaces.
If the oven spray gets into gaps and
openings, a strong odour is
generated during subsequent
cooking programmes.
Do not spray the oven cleaner onto
the roof of the oven compartment.
Do not spray the oven cleaner into
the gaps and openings of the oven
compartment walls and rear wall.
Follow the instructions on the
packaging.
Oven cleaners from other
manufacturers must only be used in a
cold oven and must not be left on for
longer than 10minutes.
If necessary, the scouring pad on the
back of a non-scratching washing-up
sponge can be used to remove the
soiling after the soaking time.
Remove any residual cleaning agent
thoroughly with clean water.
Dry all surfaces with a soft cloth.
To Next Page
Loading...
Need help?
General