Cleaning and care
95
Maintenance
The Finish at and Start at functions are
not available in maintenance
programmes.
Soak
You can use this maintenance
programme to soak stubborn soiling.
Take the accessories out of the oven
compartment.
Remove coarse soiling with a cloth.
Select Other | Maintenance| Soak.
Follow the instructions in the display.
Risk of injury due to hot steam.
At the end of the maintenance
programme, a lot of hot steam can
escape when the door is opened.
The steam can cause burns.
Step back and wait until the hot
steam has dissipated.
Once soaking is complete,
immediately remove the water and
condensate from the oven
compartment and drip channel using
a sponge or soft cloth.
Then dry the oven compartment and
the inside of the door with a cloth.
Useful tip: Once you have run the
Soakmaintenance programme, we
recommend that you run the
Dryingmaintenance programme to also
remove moisture from inaccessible
areas of the oven compartment.
Drying
You can use this maintenance
programme to dry any residual moisture
in the oven compartment, including in
inaccessible areas, and protect the
oven against corrosion.
The Drying maintenance programme
consists of up to 3 phases: residual
water evaporation in the empty oven
compartment, drying by heating up the
oven compartment and rapid cooling
with the door slightly open.
Risk of infection due to
contaminated water in the water
container.
Germs can form in the water
container if you do not run the
Dryingmaintenance programme. This
contaminated water could be
injected onto the food during the
next cooking process.
Run the Dryingmaintenance
programme to ensure that all residual
water fully evaporates.
Select Other | Maintenance|
Drying.
Follow the instructions in the display.
Use a sponge or soft cloth to remove
any water and condensation in the
oven compartment and drip channel.
If the Drying maintenance programme
has finished, switch off the steam
combination oven.
To Next Page
Loading...
Need help?
General