Miele G 7919 - Fault with the Autodos (Automatic Dispensing)

Problem solving guide
110
Fault with the AutoDos (automatic dispensing)
Problem Possible cause and remedy
The following message
appears in the display:
Insert PowerDisk or
deactivate AutoDos with OK
The AutoDosfunction is active but no PowerDisk has
been inserted.
 Insert a PowerDisk (see “Detergents - Automatic
dispensing/AutoDos”).
 If you do not wish to use automatic dispensing,
deactivate the function using OK.
The alarm tone is
sounding.
The programme does
not start or a
programme that has
already started stops.
The following message
appears in the display:
AutoDos lid open
The AutoDos lid has not been closed properly.
 Close the AutoDos lid and lock it fully (see
“Detergents - Automatic dispensing/AutoDos”).
 If the lid cannot be fully closed, check whether the
PowerDisk holder is lying flat (see “Detergents -
Inserting a PowerDisk”).
 If the same fault message appears again, call
Miele.
The following message
appears in the display:
PowerDisk empty.
Deactivate AutoDos with
OK.
The AutoDosfunction is active and the PowerDisk is
empty.
 Replace the PowerDisk (see “Detergents -
Automatic dispensing/AutoDos”).
If you do not wish to use automatic dispensing,
deactivate the function using OK.
The message
PowerDisk empty.
Deactivate AutoDos with
OK. appears in the
display even though you
have inserted a new
PowerDisk.
The dishwasher was switched off when the
PowerDisk was replaced and it has therefore not
recognised the new PowerDisk.
 Switch the dishwasher on before replacing the
PowerDisk (see “Detergents - Automatic
dispensing/AutoDos” and “Inserting a
PowerDisk”).