Miele G 7919 - Spray Arm Fault

Problem solving guide
112
Spray arm fault
Problem Possible cause and remedy
During the programme
and at the end of the
programme, the display
shows the following
message:
Check spray arms
The dishwasher does
not switch off at the end
of the programme.
The crockery may not
be clean because no
detergent was
dispensed. The
AutoDosfunction is
automatically
deactivated during the
programme sequence.
The lower spray arm is blocked or the jets of the
lower spray arm are clogged. The AutoDosfunction
is automatically deactivated during the programme
sequence because the AutoDos detergent outlet
cannot be completely flushed out.
 Switch the dishwasher off and back on.
Messages appear in the display.
 Perform a rotation check of the lower spray arm
and rearrange the crockery if it is blocking the
spray arm.
 Clean the lower spray arm (see “Cleaning and care
- Cleaning the spray arms”).
 Confirm each message with OK.
 Restart the programme.