Problem solving guide
115
Unsatisfactory cleaning result
Problem Possible cause and remedy
The dishes are not
clean.
The items were not loaded correctly.
See notes under “Loading the dishwasher”.
The programme was not thorough enough.
Select a more intensive programme (see
“Programme chart”).
Activate the “Extra clean” function (see “Extras –
Extra clean”).
Activate the “2nd interim rinse” function (see
“Settings - 2nd interim rinse”).
Not enough detergent was dispensed.
Use more detergent during manual dispensing or
change the detergent you are using.
Increase the dispensing quantity during automatic
dispensing (if available) (see “Settings – AutoDos”).
Items are blocking the path of the spray arms.
Carry out a rotation check and if needed rearrange
the items so that the spray arms can rotate freely.
The filter combination in the base of the wash
cabinet is not clean or not correctly fitted.
This may have caused the spray arm jets to become
blocked.
Clean and/or fit the filter combination correctly.
Clean the spray arm jets if necessary (see
“Cleaning and care - Cleaning the spray arms”).
There are smears on
glassware and cutlery.
There is a bluish sheen
on the surface of
glassware. The film can
be wiped off.
The rinse aid dosage is set too high.
Reduce the dosage (see “Settings - Rinse aid”).
To Next Page
Loading...
Need help?
General
