Cleaning and care
95
Cleaning the AutoDos
You should check that the detergent
fill channel is clean every time you
replace the PowerDisk, and clean it if
necessary, e.g. powder residues.
This should be done at the latest
when the Clean AutoDos message is
displayed. This helps keep the
AutoDos working properly.
In order to ensure that the AutoDos
works at its best, check it each time
you replace the PowerDisk and clean
it if needed.
1 PowerDisk holder
2 Detergent chute for dispensing the
detergent from the PowerDisk into the
wash cabinet
Slide the yellow catch of the AutoDos
lid to and open it.
Remove the PowerDisk if applicable.
Pull the PowerDisk holder upwards
by the yellow tabs and remove it.
When doing so, do not pull on the
side tab.
Use the tab (see arrow) to release
the fill channel and pull it out.
To Next Page
Loading...
Need help?
General
